Browns Brain THERE'S NOTHING SMARTER THAN A BRAIN!

Home
BB029 Hotend Declogger
This is a simple and inexpensive tool used to quickly push out a clog from the hotend. Simply insert into the hot hotend and push as needed to force the clog out the nozzle. In some extreme clogs, it may be better to remove the nozzle first. Length is 20cm or 14cm long, stainless steel.

In direct drive systems:
1) Be sure to remove all extruder tension and ensure a direct path into the hotend.
2) Remove the filament from the hotend.
3) Now insert the shaft of the tool into the hotend as if you were pushing filament into the hotend.

In Bowden systems:
1) Remove the Bowden tube first.
2) Remove the filament from the hotend.
3) Now insert the shaft of the tool into the hotend as if you were pushing filament into the hotend.
The clog will be pushed out the nozzle or in the extreme clog, it will be pushed out the heat break and through the heater block. A quick fix for what is usually a tedious procedure. color may vary... hotend not included...



Add 20cm Declogger to cart.
Add 14cm Declogger to cart.